I am having trouble getting email Bounce Handler to work

ethanc

New Member
Hi there,

Here is the report from my log:
6/8 16:12:38 ~ Status: Connecting to xxxx.xxxxxx.internal (IMAP) Port: 143 Security: None
6/8 16:12:38 * OK Microsoft Exchange Server 2003 IMAP4rev1 server version 6.5.7226.0 (xxxx.xxxxxx.internal) ready.
6/8 16:12:39 ~ Status: Connected to IMAP server
6/8 16:12:39 > A0001 LOGIN xxxxx ********
6/8 16:12:39 A0001 OK LOGIN completed.
6/8 16:12:39 > A0002 SELECT Inbox
6/8 16:12:39 * 1 EXISTS
6/8 16:12:39 * 1 RECENT
6/8 16:12:39 * FLAGS (\Seen \Answered \Flagged \Deleted \Draft $MDNSent)
6/8 16:12:39 * OK [PERMANENTFLAGS (\Seen \Answered \Flagged \Deleted \Draft $MDNSent)] Permanent flags
6/8 16:12:39 * OK [UNSEEN 1] Is the first unseen message
6/8 16:12:39 * OK [UIDVALIDITY 1591] UIDVALIDITY value
6/8 16:12:39 A0002 OK [READ-WRITE] SELECT completed.
6/8 16:12:39 ~ Status: Mailbox pointer = 1
6/8 16:12:39 ~ Status: Total messages in Mailbox = 1
6/8 16:12:39 > A0003 PARTIAL 1 RFC822 1 25000


At this point, the status line says "Getting message 1/1" and sits... and sits... and stits. Any ideas?
 

howaraj

New Member
I too get this problem. Did you find out how to fix this?

My install was working fine as a trial a coupe of days ago, but once registered today and retryed I get the same message when trying to fetch emails?
 

ethanc

New Member
Actually I did...

Figured out that almost all the messages on the server were way bigger than 25k. I turned that off and it worked like a charm!
 

stanbusk

Administrator
Staff member
Yes, this is because the IMAP PARTIAL command is buggy on several server implementations. Deactivating the size setting causes eMail Bounce Handler to use IMAP Fetch command instead.
 
Top